Эксплуатация – АВТОМАТИЧЕСКИЙ РЕЖИМ
OPTIMA FULL DIAGNOSTIC
Operation - AUTOMATIC
"OPTIMA FULL DIAGNOSTIC"
7.12 Режим OPTI LINE
OPTI LINE -
,
PULL ..
,
.
OPTI LINE (
OPTIMA OPTIMA FULL DIAGNOSTIC)
.
.
Set of Wheels OPTI LINE.
Set of Wheels
,
,
.
.
().
.
.
Примечание: OPTI LINE
Optima Settings
7.10.6.1.
Enabled Optima Settings
/ Wheel Pull Measurement OK
7.12.1 Процедура для комплекта колес
•
6.
•
OPTIMA
OPTIMA FULL DIAGNOSTIC
7.
•
7.10.1.
:
•
F5 (1, Рис. 7-100)
OPTI LINE.
•
F5 2 (Рис. 7-100),
Set of Wheels.
Примечание: Set of
Wheels
(Рис. 7-101).
7.12 OPTI LINE mode
The OPTI LINE mode is a computerised function designed
to improve the vehicle effect, that is to say, the
lateral pull force caused by excessive tread conicity, as
well as to minimise the vibrations caused by any residual
wheel unbalance.
With the OPTI LINE mode (function possible in OPTIMA
mode or in OPTIMA FULL DIAGNOSTIC mode) the
balancer analyses a set of wheels, saving data such as
the Runout and the tread conicity index. When the
procedure is complete the machine selects the best four
wheels, suggesting the order in which they should be
mounted to minimise the lateral pull force they produce
on the moving vehicle or to minimise the vibrations.
The effect and the vibrations of the wheels can be
reduced with the of procedure, in the OPTI
LINE mode.
Start the t of Wheels procedure and the run, then
complete compensation of the unbalance, remove the
wheel from the balancer and finally assign the wheel to
the Set, saving its data.
Once the fourth wheel is entered, the machine proposes
an initial mounting order. You can also proceed and enter
a fifth wheel (usually the spare wheel).
After entry of the fifth wheel, the program selects and
proposes the best four wheels with the relative mounting
suggestion. Entering five wheels allows for greater
mounting combinations and therefore greater opportunities
for correcting the faults.
Note: The OPTI LINE mode must be previously enabled
in the a Settings Menu
7.10.6.1.
Select the following:
Optima Settings / Wheel Pull Measurement, set
Enabled and press OK
7.12.1 Procedure “Set of Wheels”
Lock the wheel
6.
Check that the OPTIMA or OPTIMA FULL
DIAGNOSTIC mode is active
7.
Start the measuring run
7.10.1.
At the end of every measuring line proceed as follows:
Press F5 (1, Fig. 7-100) to switch on the OPTI LINE
Mode.
Press F5 and select Item 2 (Fig. 7-100) to switch on
the Set of Wheels
procedure.
Note: on, the
status bar shows the relative icon (Fig.7-101).
To Next Page
Loading...