Руководство по эксплуатации
7.2.2 Функция Easy Alu Toggle
Автоматическая корректировка режима Alu
Alu
.
Alu ,
"Easy Alu Toggle".
• F4 (Рис. 7-7)
Alu.
Примечание:
Alu
(
Alu).
7.3 Настройки меню
(
TD
TRX).
.
.
(Рис. 7-9)
(Рис. 7-9):
• (Рис. 7-8) F1
MENU .
(Рис. 7- 9).
Примечание:
.
7.2.2 "Easy Alu Toggle" function
Automatic correcting the Alu proposed
Depending on the gauge contact points on the rim, the
machine has interpreted a probable Alu mode required
by the user. Every time the Alu presented by the machine
does not correspond exactly to the one required it can be
corrected using the "Easy Alu Toggle" function.
Press the F4 key (Fig. 7-7) if you want the alternative
Alu mode to that suggested for the rim being worked on.
Note:
The Alu can only be changed before the run or before
the imbalance display request (gauges are applied after
the run to select a completely different Alu.
7.3 Menu settings
The wheel dimensions to be entered are usually given on
the rim (in inches or mm on standard wheels, in mm on TD
or TRX wheels). Rim diameter is also given on the tyre.
Read the rim dimensions before clamping the wheel on
the balancer
To make a setting using the Menu, access the
BALANCING screen (Fig. 7-9), or the RIM DATA ENTRY
screen (Fig. 7-9):
On the main Menu (Fig. 7-8) press the F1 MENU key
and select the RIM DATA ENTRY.
The RIM DATA ENTRY screen (Fig. 7- 9) will open.
Note:
All the basic selections can be made in the same way
from the BALANCING and RIM DATA ENTRY menus.
To Next Page
Loading...