11. Коды ошибок
Операционные ошибки
- E-Коды
Предупреждения
- H-Коды
Критические ошибки - 300 или C10
E1
.
• .
E2
.
E3
.
E4
.
E5
(
).
• STOP ESC.
•
.
11. Error codes
Errors in operation - Error code E
Warnings - Error code H
Fatal error code - 300 or C10
E1
Rim dimensions were entered incorrectly, or incompletely.
• When the error code is read out, enter data once
again.
E2
Wheel guard is not closed.
E3
The gauge arm for distance and rim diameter is not in
home position.
E4
The width gauge arm is not in home position.
E5
Range of electrical compensation exceeded
(wheel adaptor has unacceptable unbalance).
• Press STOP or ESCkey.
• Check wheel adaptor, repeat
compensation run.
E6
.
• STOP ESC.
• .
E7
.
• .
E8
).
•
OP.
E6
The calibration weight was not fitted for readjustment.
• Press STOP or ESCkey.
• Repeat readjustment.
E7
With this wheel type it is not possible to choose a
balancing mode.
• If necessary, choose another wheel type.
E8
Valve position was not entered in electronic unit (error
code only in optimisation or minimisation programs).
• Position valve exactly perpendicular to and above
main shaft and press the OP key.
To Next Page
Loading...