5. Включение станка
Внимательно изучите руководство по
эксплуатации и следуете его указаниям,
особенно, если работа на станке производится
в первый раз.
•
.
•
(1, Рис. 5-1).
•
(
2,
Рис. 5-1).
.
WAIT: LOADING...
(Рис. 5-2).
.
.
(Рис. 5-3),
.
Рис. 5-3
F1…F6:
F1
F2
F3
F4 : ,
, / , Weight Miser -
F5
F6
5.1 Статус при включении
:
1 (
,
6,5" 15,0").
, : .
5
( 3,5 .).
.
.
START.
5. Switching on the machine
Please read through the operation manual and
follow the instructions, especially when operating
the wheel balancer for the first time.
Always make sure the wheel guard is fully raised.
Plug the mains cable plug into the power outlet
(1, Fig. 5-1).
Switch on the machine by the mains switch (2, Fig. 5-1).
The electronic unit now performs a number of self-tests.
In this phase this message is displayed on the screen
WAIT: LOADING...(Fig. 5-2).
As long as the machine is carrying out the self-tests, no
inputs and no other operations whatsoever must be made.
During this starting phase the machine must not be
subjected to even the slightest vibrations.
Upon completion of the self-tests a melodious signal is
heard, the screen shows the main menu (Fig. 5-3) and
the machine is ready for operation.
Fig. 5-3 Main menu
The menu fields of the function keys F1 to F6 show:
F1 Access to BALANCING
Access to ENTERING RIM DATA
Access to OPTIMISATION
Access to SETTINGS
F2 Not assigned
F3 Not assigned
F4 Selection of: Static unbalance, Weights Fine Reading,
Grams / Ounces, Weight Miser
F5 Not assigned
F6 Access to COMPENSATION RUN
5.1 Status at switching on
The electronic unit is factory-adjusted to the following
operating modes, available immediately after switch on:
PROFILING mode
Weight mode 1 (car wheel with nominal dimensions in
inches, width 6.5" and diameter 15.0").
Acquisition of rim data, unit of measurement: inches.
Display of unbalance value with 5 gram increments.
Suppression of minor unbalance readings (tolerance
limit set at 3.5 g).
Automatic wheel braking when guard is opened during
the measuring run.
Compensation of adaptor unbalance switched off.
Start of measuring run by START key only.
To Next Page
Loading...