Installation Instructions
i. Требования к месту установки.
Необходимая площадь.
.
i.1 :
1 :
.
2 :
Требования к полу.
:
- ; +/- 1
- ; 2
- ,
2
.
, ,
.
.
.
. .
Примечание:
.
Требования сети питания.
. 2
ВНИМАНИЕ:
.
ВНИМАНИЕ
.
i. Installation requirements.
Space requirements.
The drawings show the minimum safety requirements.
Drawing i.1 has two sets of dimensions:
1 dotted lines: for measurements regarding the holes
for fixing the machine to the floor.
2 continuous lines: for measurements regarding overall
machine surface space
Floor requirements.
The floor should be:
- horizontal; +/- 1 tolerance
- even; within 2 mm
- able to bear the weight of the balancer as stated in
Chapter 2 of the Manual.
The floor on which the balancer will be installed should
not relay vibrations from other devices or from outside the
building. External vibrations may affect the accuracy of
the unit.
The machine can operate even if it is not fixed to the floor
as long as it rests correctly on the floor at the three points
indicated.
The balancer must be positioned directly on the floor. Do
not use spacers to fill gaps.
Note:
If metal spacers are used to achieve the necessary
floor conditions for installation, the machine must be
secured to guarantee long term stability.
Power supply requirements.
Refer to Chapter 2 of the s Manual for mains
power requirements.
WARNING: ENSURE THAT AN APPROVED WALL
MAINS OUTLET IS AVAILABLE.
WARNING: NEVER GUIDE POWER SUPPLY CABLES
OVER THE FLOOR, UNLESS PROTECTED BY AN
APPROVED COVER.
To Next Page
Loading...