EasyManua.ls Logo

John Bean BFH 2000 - Счетчики; Текстовый Редактор; Counters; Imput of Promotional Text

John Bean BFH 2000
264 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Параметры настроек
Setting Parameters
BFH 2000
227
10.2 Счетчики
   
 .  
  999999.   
.  ,
,   ,
,    
      
     
   
      
.     
.
   (1, Рис.10-3)
  (Рис. 10-2).  
:
Список счетчиков (Рис. 10-3)
a Total spins =
b Spins with = 
o.k. 
c Optimisation = 

d Service = 

e Since last = 
calibration 
f Clamps = 
10.3 Текстовый редактор

 (Рис. 10-2), 
 
    OK  F5 
.
   ;
  (3, Рис.10-4)   
 .  :
Рис. 10-4
F1 
F2 
F3 
F4  
F5 : , ,
.
F6 .
10.2 Counters
Every measuring run actually completed is stored.
Maximum count is 999,999 runs. Once this number is
reached, the counter is reset to zero. The information is
primarily useful for statistical purposes, e. g. to obtain
evidence of load intervals of parts when defective, or of
monthly (yearly) use of the machine, etc. The measuring
runs performed while the machine is on are transferred
into the permanent memory and added when it is switched
off. The counter cannot be reset or changed.
Select the "Counters" category (1, Fig.10-3) in the
SETTINGS screen (Figure 10-2) .The data immediately
available in the Values field are the following:
List of Counters (Figure 10-3)
a Total spins = Total number of measuring runs
b Spins with = Number of measuring runs where
o.k. balance quality was considered OK
c Optimisation = Number of optimisations or
runs minimisations
d Service = Number of measuring runs in
service mode
e Since last = Number of measuring runs
calibration since the last calibration
f Clamps = Total number of wheels clamped
10.3 Input of promotional text
Select the "General Settings" category in the
SETTINGS screen (Fig. 10-2), then select one of the
5 parameters in the central panel "Promotional Text"
and enter it using the OK or F5 key.
The TEXT COMPOSITION mode is activated; in the Values
field (3, Fig.10-4) a point identifies the position where the
text will be entered and the Menu keys are assigned
different functions as follows:
Figure 10-4
Menu key functions in TEXT COMPOSITION mode
F1 Not assigned
F2 Moves back by one character on the line
F3 Moves forward by one character on the line
F4 Opens Character Types menu
F5 Opens the Menu: Save text, Restore "UNDO" text,
Delete text.
F6 Not assigned.

Table of Contents