Руководство по эксплуатации
7.5 Функция профиля колеса
.
.
,
.
.
).
,
.
:
, (Alu P)
(Mod Alu)
( 1 9)
()
Рис. 7-22
:
F1
F2
F3
F4
F5
F6
7.5 Wheel Profiles function
To balance more than one wheel of the same type and
with the same nominal dimensions, simply set the data
for the first wheel only. The data set then remains until
other new data is set or the machine is switched off.
To make the wheel parameters available permanently use
the WHEEL PROFILES function.
The wheel profiles function enables you to memorize the
values of certain wheel types that are often balanced in
the garage. Naturally this bypasses the task of repeatedly
setting wheel data. This function is particularly useful for
workshops that carry out series fitting of tyre/rim
assemblies or frequently handle the same wheel types
(e.g. workshops that offer rims for retrofitting).
The onceonly storage of the rim data in the profiles
guarantees that the same correction planes are always
used, in particular for alloy wheels, thus providing
consistent balance quality.
The function can be used to save the following data:
Nominal wheel dimensions
Values measured with gauge (Alu P)
Position of weights (Modo Alu)
Type of Vehicle
Traceability positions (list from 1 to 9)
Number of spokes (if loaded previously)
Fig. 7-22 PROFILE
Assignment of menu fields:
F1 Access to Basic Menu
F2 Not assigned
F3 Saves current profile in permanent memory
F4 Not assigned
F5 Applies a wheel profile selected from the memory
F6 Not assigned
To Next Page
Loading...