Эксплуатация – АВТОМАТИЧЕСКИЙ РЕЖИМ
OPTIMA FULL DIAGNOSTIC
Operation - AUTOMATIC
"OPTIMA FULL DIAGNOSTIC"
7.11.1.1.1 Функция печати состояния
протектора “TREAD CONDITION REPORT”
.
:
•
.
•
6.
• OPTIMA FULL DIAGNOSTIC
7.11.
•
7.10.1.
• , 7…10
(Рис. 7-83),
.
•
.
(Рис. 7-83a).
•
(TREAD CONDITIONS REPORT)
4 F6 (Рис. 7-83a).
,
7.11.2.1
.
7.11.1.1.2 Меню режима “OPTILINE”
(PULL),
, ,
.
(Set of Wheels),
OPTILINE.
OPTILINE 13
F5 (Рис. 7-83)
OPTIMA OPTIMA FULL
DIAGNOSTIC.
7.12.1.
PULL
.
7.11.1.1.1 “TREAD CONDITION REPORT” Function
This function is used each time that you want to save a
detailed report of the tread condition.
Using the function:
• Before removing the wheels from the vehicle, in order
to remember their position, mark each wheel with its
position.
• Lock the wheel
6.
• Select OPTIMA FULL DIAGNOSTIC
7.11.
• Perform the Measuring run
7.10.1.
• After the run, with the items 7 to 10 (Fig. 7-83), assign
the position of the wheel on the vehicle.
• Perform all the above for all the wheels concerned.
Once the set of wheels is finished, print the data stored
in the memory (Fig. 7-83a).
• Select Item 4 of the F6 Menu (Fig. 7-83a) to print the
TREAD CONDITIONS REPORT.
The Report shows the information previously shown on
the screen
7.11.2.1 for each wheel and the notes for
the tread.
7.11.1.1.2 “OPTI LINE” Menu
The reduction of the PULL caused by excessive tread
conicity and the reduction of the vibrations transmitted
by the wheels to the vehicle often cannot be resolved
with the balancing and the wheel setup. The Set of Wheels
function is available to this end in the OPTI LINE Mode.
The OPTI LINE Mode is enabled with Item 13 of the F5
Menu shown on the side (Fig. 7-83) and it can be executed
either in OPTIMA or OPTIMA FULL DIAGNOSTIC mode.
See the t of Wheels procedure
7.12.1.
At the end of the procedure you can select whether to
reduce the effect or reduce the effect of the
vibrations caused by the wheels.
To Next Page
Loading...