Руководство по эксплуатации
7.7 Проверка биений
Проверку радиального и бокового биений
рекомендуется проводить перед выполнением
измерительного цикла, поскольку большие
биения могут свидетельствовать о
неправильном монтаже шины, что вообще не
позволяет произвести балансировку.
-
(
automatic braking when wheel guard is raised
enabled
( disabled) .
10. .
(disabled):
ВНИМАНИЕ: ПРИ ОТКРЫТОМ ЗАЩИТНОМ
КОЖУХЕ КОЛЕСО ПРОДОЛЖАЕТ ВРАЩАТЬСЯ.
УБЕДИТЕСЬ, ЧТОБЫ КОЛЕСО НЕ БЫЛО
ЗАБЛОКИРОВАНО ИНСТРУМЕНТОМ ИЛИ
ДРУГИМИ ПОДОБНЫМИ ПРЕДМЕТАМИ.
НОСИТЕ ОЧКИ И ПЛОТНО ПРИЛЕГАЮЩУЮ
РАБОЧУЮ ОДЕЖДУ.
•
START
.
•
.
•
STOP.
7.7 Axial Run-out test
Prior to the measuring run check the wheel for radial
and lateral run–out. If considerable run–out is
observed the tyre may be incorrectly fitted on the
rim. In this case, the wheel should not be balanced.
When supplied from our works the machine is programmed
such that the wheel is braked automatically when the
wheel guard is raised (mode of operation
braking when wheel guard is set to
Observation of the wheel is only possible when this mode
of operation is set to (no braking of wheel by
raising of wheel guard, se10. Changing modes of
operation).
If the mode is set to
WARNING: THE WHEEL ROTATES WHEN THE
WHEEL GUARD IS OPEN.
MAKE SURE THAT THE WHEEL IS NOT BLOCKED
BY TOOLS OR THE LIKE.
WEAR SAFETY GOGGLES AND TIGHTLY FITTING
WORKING CLOTHES.
• If the wheel clamped on the balancer is to be checked
for visible radial and/or lateral run-out, perform a visual
check by lowering the wheel guard and pressing the
START key, prior to the actual measuring run.
• Then raise the wheel guard and observe the wheel for
radial and lateral runout while it slows down.
• Finally brake the wheel by operation of the STOP key.
To Next Page
Loading...