10. Выбор и установка параметров
-.
.
.
Вызов окна НАСТРОЕК
• F1 (Рис. 10-1)
(1, Рис. 10-1).
Рис. 10-2,
(1, Рис. 10-2),
().
ПРОКРУТКИ OK.
.
.
КАТЕГОРИИ (1, Рис. 10-2)
• ПРОКРУТКИ,
:
- General Settings (Общие настройки)
- Measurement Settings (Настройки измерений)
- Optima Settings (Настройки режима Optima)
- Network and Print (Сеть и Печать)
- Counters (Счетчики)
- System information (Информация о системе)
• OK.
(2,
Рис. 10- 2).
ПАРАМЕТРЫ (2, Рис. 10-2)
• ПРОКРУТКИ .
• OK.
(3, Рис.
10-2),
.
ЗНАЧЕНИЯ (3, Рис. 10-2)
•
(ПРОКРУТКА + OK).
Примечание:
.
F3
.
• F1 1
(1, Рис. 10-2a).
10. Operating Mode - Selecting
and Setting Parameters
Normal operation usually does not require any modification
of the factoryadjusted modes of operation or their
factoryadjusted state.
Variations, however, can be made by selecting certain
specific items in the SETTINGS screen.In addition to the
changes made to the functioning modes, from this menu
various counters can be displayed showing the operations
carried out over time by the balancer.
Recalling the SETTINGS screen
• Press the F1 Menu key on the main menu (Fig. 10-1)
and select the SETTINGS item (1, Fig. 10-1).
The SETTINGS screen Figure 10-2 will open and the
Basic List panel will be immediately active (1, Fig. 10-2),
(CATEGORIES).
The various items can be selected using the SCROLL
command and then by confirming with OK.
An active panel presents an illuminated image of the flange.
When an item is selected the panel that contains it turns
a darker colour.
CATEGORIES (1, Figure 10-2)
• Using the SCROLL command select a Category:
- General Settings
- Measurement Settings
- Optima Settings
- Network and Print
- Counters
- System information
• Confirm by pressing the OK key.
This takes you to the central PARAMETERS panel (2,
Fig. 10- 2).
PARAMETERS (2, Figure 10-2)
• Use SCROLL to select a parameter.
• Confirm by pressing the OK key.
The selector shifts to the VALUES panel (3, Fig. 10-2)
so that changes can be made or information acquired.
VALUES (3, Figure 10-2)
• Select the desired item and confirm the change following
the procedure explained previously (SCROLL + OK).
Note:
Values cannot be changed in the Counters or
Information categories.
The F3 key activates alternately the CATEGORIES
and the PARAMETERS panel.
• Press the F1 key to return to the INTRODUCTION
screen and select the relative item (1, Fig. 10-2a)
To Next Page
Loading...