Эксплуатация – АВТОМАТИЧЕСКИЙ РЕЖИМ
OPTIMA FULL DIAGNOSTIC
Operation - AUTOMATIC
"OPTIMA FULL DIAGNOSTIC"
7.11.1 Меню режима OPTIMA FULL DIAGNOSTIC
OPTIMA FULL
DIAGNOSTIC.
"4.4 ",
.
OPTIMA FULL DIAGNOSTIC
OPTIMA
.
F2
("ASSEMBLY RUNOUT INDICATION") (Рис.
7-41)
OPTIMA FULL DIAGNOSTIC:
1 "TREAD PLOT"
2 "3D PLOT" 3D-
7.11.1.1 Меню "TREAD PLOT"
"TREAD PLOT" (Рис. 7-83)
1 F2 (Рис. 7-41)
.
.
:
(Рис. 7-83)
F2:
1 "ASSEMBLY RUNOUT
INDICATION".
2 "3D PLOT", .
3 "Lens", .
4 "TREAD PLOT", .
5 "INTERNAL SIDEWALL", .
6 "EXTERNAL SIDEWALL", .
F5 TREAD PLOT (Рис. 7-83)
.
TREAD CONDITIONS REPORT
F5:
7, 8, 9, 10
.
7 .
8 .
9 .
10 .
11 .
12 TREAD
CONDITIONS
13 OPTI LINE.
7.11.1 “OPTIMA FULL DIAGNOSTIC” Menus
This section sets out the specific functions of the "OPTIMA
FULL DIAGNOSTIC" mode and only the Menu items that
refer to this mode.
For information about the other items and icons, refer to
the basic chapter "4.4 The Menus", as well as the
Automatic Modes specifications described earlier.
The "Optima Full Diagnostic" function selection items are
already displayed from the "OPTIMA" Automatic Mode.
Their use is only possible in the "OPTIMA FULL
DIAGNOSTIC" mode, with the maximum data reading
precision of the cameras.
The F2 Menu in the "ASSEMBLY RUNOUT INDICATION"
screen (Fig. 7-41), contains the items to access the
"OPTIMA FULL DIAGNOSTIC" analysis screens:
1 Access the "TREAD PLOT" screen
2 Access the "3D PLOT" screen
7.11.1.1 "TREAD PLOT" menu
The "TREAD PLOT" screen (Fig. 7-83) is accessed with
Item 1 of the F2 Menu (Fig. 7-41) in the "ASSEMBLY
RUNOUT INDICATION" screen.
The screen presents a graphical and numerical analysis
of the wheel tread.
The screen contains the following Menu Items:
(Fig. 7-83)
F2 Menu:
1 Go back to the "ASSEMBLY RUNOUT INDICATION"
screen.
2 "3D PLOT", 3D view.
3 "Lens", zoom and reset graphic image.
4 "TREAD PLOT", tread analysis.
5 "INTERNAL SIDEWALL", internal sidewall analysis.
6 "EXTERNAL SIDEWALL", external sidewall analysis.
The F5 Menu in the TREAD PLOT screen (Fig. 7-83) is
used to memorise the tread wear data of from one to four
wheels of a vehicle. Once the first wheel is entered the
TREAD CONDITIONS REPORT printout, containing the
information stored, is available.
F5 Menu:
Items 7, 8, 9, 10 store the data of every wheel, assigning
its position on the vehicle.
7 Assigns the position left front wheel.
8 Assigns the position - right front wheel.
9 Assigns the position - left rear wheel.
10 Assigns the position - right rear wheel.
11 Deletes the last wheel position assigned.
12 Resets the TREAD CONDITIONS function data.
13 Access the OPTI LINE mode.
To Next Page
Loading...