Эксплуатация – АВТОМАТИЧЕСКИЙ РЕЖИМ
OPTIMA FULL DIAGNOSTIC
Operation - AUTOMATIC
"OPTIMA FULL DIAGNOSTIC"
7.11 Режим OPTIMA FULL DIAGNOSTIC
.
7-82.
.
.
,
• F1 (4,
Рис. 7- 47).
• :
"Optima Full Diagnostic"
"OPTIMA Set up / Wheel balancer operating mode"
( OPTIMA / )
"OK".
Примечание:
OPTIMA FULL
DIAGNOSTIC.
.
( )
.
, ,
.
, :
, , ,
,
.
Примечание:
OPTIMA FULL
DIAGNOSTIC
OPTIMA
.
7.11 "OPTIMA FULL DIAGNOSTIC"
Optima Full Diagnostic Mode
The following instructions describe the specific functions
of the wheel balancer in "OPTIMA FULL DIAGNOSTIC"
mode.
The icon shown in fig. 7-82 indicates the "OPTIMA FULL
DIAGNOSTIC" mode is active. The unit operates in
Automatic Mode.
When the "OPTIMA FULL DIAGNOSTIC" mode is set with
the set up panel, the machine performs the Automatic
Advanced wheel data reading procedure.
To enable the mode with the "SET UP" screen,
• Press the F1 Menu Key and select Set Up (4,
Fig. 7-47).
• select the following:
"OPTIMA Set up / Wheel balancer operating mode",
set "Optima Full Diagnostic" and press "OK".
Note:
All the functions described in the previous Automatic
Modes, are also available in the "OPTIMA FULL
DIAGNOSTIC" Mode.
The difference with this function is the date reading
precision of the cameras, which allow for three
dimensional images of the wheel to perform an in-depth
structural analysis of the tyre and rim.
The images, both flat and three dimensional, are presented
graphically with a colorimetric gradation.
The changes in the colours of the wheel displayed on the
screen, indicate the structural and physical conditions of
the parts.
The operator is able to asses the degree of wear of the
tread with a quick visual analysis and easily identify any
irregularities or anomalies such as: flattening, bulges,
bubbles on the sidewalls, lack of homogeneity, cuts, and
abrasions and surface imperfections, even small and
difficult to see with the naked eye, both on the tread and
the sides of the tyre.
Note:
Measuring runs in "OPTIMA FULL DIAGNOSTIC"
mode require a longer Cycle Time, due to the high
precision three dimensional data reading, compared to
the Time required with the "OPTIMA" runs.
To Next Page
Loading...