13. Обслуживание
.
.
.
.
.
.
.
(
11)
.
ВНИМАНИЕ: ПЕРЕД ОБСЛУЖИВАНИЕМ ИЛИ
РЕМОНТОМ СТАНКА ОТКЛЮЧИТЕ ЕГО ОТ
ИСТОЧНИКА ПИТАНИЯ И ОБЕСПЕЧЬТЕ ЗАЩИТУ
ОТ СЛУЧАЙНОГО ВКЛЮЧЕНИЯ.
Примечание:
, .
13.1 Периодичность чистки
Еженедельно:
Окно задней камеры
(1, рис. 13-1)
,
.
•
.
,
•
.
13. Maintenance
The internal mechanical parts of your equipment require
almost no maintenance. All the bearings are greased for
life and sealed. The drive belt does not require particular
checks.
Particular attention should be paid to the wheel centering
cones and the relative clamping parts, that must always
be clean and in a good state. Always keep the wheel
clamping equipment thoroughly clean, both during
operation and when not in use. When not in use lubricate
all metal parts with non-corrosive oil and store in a dry
and safe location. Balance quality depends considerably
on their condition.
If defects occur which cannot be eliminated by the user
(error codes not mentioned unde 11. Error codes),
contact the after-sales service.
WARNING: PRIOR TO MAINTENANCE OR REPAIR
WORKDISCONNECT THE MACHINE FROM THE MAINS
SUPPLY AND PROTECT AGAINST
UNINTENTIONALSWITCHING ON.
Note:
This unit must not be opened by the operator, apart
from following the instructions below.
13.1 Programmed Cleaning
Every Week:
Rear Camera glass
The seating of the rear Camera (1, fig. 13-1) is fitted with
a protective glass, which must be cleaned regularly.
Clean only with a non-synthetic, clean, dry and soft
cloth in order not to scratch the surface of the glass.
To remove oil or grease,
wet the cloth slightly with a specific glass detergent
can clean carefully.
To Next Page
Loading...