6. Зажим колеса
Рис. 6-1 A
ПЕДАЛЬ ВНИЗ: Остановка вращения
.
.
ПЕДАЛЬ ВВЕРХ: МЕХАНИЧЕСКИЙ ЗАЖИМ
.
Рис. 6-1 B
Механический зажим с полностью открытыми
губками.
Рис. 6-1 C
Механический зажим с полностью закрытыми
губками.
.
6.1 Установка механического зажима
Power Clamp
Рис. 6-2
Примечание:
Power Clamp On
C22.
”Releasing the power clamping device is
disabled” (Ослабление крепления
механического зажима Power Clamp
отключено).
.
.
(
) .
.
,
.
,
.
.
.
6. Clamping the wheel
Fig. 6-1 A
The main shaft lock pedal has two functions
PEDAL DOWN: Stopping rotation
The shaft angle is locked when the pedal is depressed.
This lock is designed only to facilitate orientation of the
wheel and must not be used for braking the main shaft.
PEDAL UP: POWER CLAMP lock
The pedal also controls the POWER CLAMP, for clamping
the wheel on the balancer.
Fig. 6-1 B
Power Clamp with jaws fully open.
Fig. 6-1 C
Power Clamp with jaws fully closed.
By changing the mode of operation it is possible to reverse
the direction of actuation of the pedal.
6.1 Fitting the Power Clamp device
Figure 6-2
Note:
If the machine is retooled for the power clamping
device, reset the mode of operation C22 to status On
”Releasing the power clamping device is
disabled”.
Move the clamping jaws to unclamped position.
Unscrew the taper nut and place aside.
Remove the special clamping means, if mounted, from
the cone of the main shaft.
Mount the basic body of the clamping device, screw it
onto the tie rod by turning it to the end of the thread
and then release it again by a quarter of a revolution.
Slide the basic body by hand onto the cone, inserting
the screw heads through the bayonet disc.
Turn the basic body until the screw thread is contacting
the bayonet disc.
Slide on the clamping sleeve with clamping head and
clamp.
Tighten the screws evenly with an open end wrench,
width across flats 13 mm.
To Next Page
Loading...