Руководство по эксплуатации
7.4 Режим специальных размеров
•
F5, (1,
Рис. 7-15).
(Рис. 7- 20).
Примечание:
,
(
)
.
ALU 0 .
.
•
(Рис. 7-21).
• F2, F3 F4
.
.
• .
• .
.
.
7.4 Special Dimensions mode
• In the ENTERING RIM DATA screen press the menu
key F5, then select the Special Dimensions item (1,
Fig. 7-15).
The ENTERING RIM DATA screen appears where the
weights highlighted on two planes appear in a square
shape (Fig. 7- 20).
Note:
The Special Modes function is not used for the normal
balancing procedures but only if it is not possible to
use a programmable weight position (e.g. in the case
of special wheels), with complex dimension
parameters beyond the automated mechanisms on
the machine.
The ALU 0 mode is automatically recalled when selected.
The dimensions are always displayed in millimetres.
•
Measure directly on the wheel to be balanced the
distance X and the effective compensation measurements
(weight barycentre) using a flexible tape measure (Figure
7-21).
• Press key F2, F3 or F4, according to the dimension
you wish to alter.
The value involved in the alteration takes on a coloured
identification frame.
• Using the scroll cursor change the value, until the value
displayed corresponds to the value measured.
• When this value is reached press the same key again.
The rim dimensions are now entered completely. The
input is retained until a new input is made or until the
machine is turned off.
To Next Page
Loading...