Балансировка и установка грузов
Balancing and weights Fitting
8.3 Контрольный цикл
•
.
,
,
0
OK (Рис. 8-15).
Примечание:
OK ,
(
3,5.)
.
1 F4 (Рис. 8-
15)
8.3 Test Run
• After applying the balance weights perform a Test Run.
Having finished the Test Run, if the wheel is balanced
correctly, both the numerical indicators should indicate 0
and an OK should be displayed (Fig. 8-15).
Note:
If there is no OK reading, dynamic unbalances below
the tolerance limit (suppression preset to 3.5 g) add to
a static unbalance above the tolerance limit. Press the
end indication key in Menu F4 (1,Figure 8-15) and the
residual imbalance values will appear for several seconds
and then they can be eliminated.
To Next Page
Loading...