Руководство по эксплуатации
7.6 Корректировка данных после измерения
/
:
• (F1).
• F5 1 (Рис. 7-15).
,
7.3.3.
.
Примечание:
Alu P.
Alu
Alu P.
7.6 Correction of inputs after
measurement
If incorrect data and/or incorrect wheel type or balancing
mode were entered for a measuring run (Type of Vehicle,
Alu Mode):
To reset the corrected rim dimensions and/or the
corrected measurement methods
• Return to the ENTERING RIM DATA screen (Menu F1).
• Press the F5 Menu key to select the item (1, Fig.7-5).
The EDIT MEASUREMENTS function screen opens so
proceed as described in Chapter 7.3.3.
At the end of the process the electronic control unit
acquires the new settings, processes and displays the
corrected measurement values in the BALANCING screen
without having to launch another run.
Note:
Entry of a new datum via manual setting involves exit
from any preselected Alu P mode. The machine will
present the nominal Alu corresponding to the Alu P
set before
To Next Page
Loading...