Эксплуатация – АВТОМАТИЧЕСКИЙ РЕЖИМ "PROFILING"
Operation - AUTOMATIC “PROFILING”
7.8.2 Измерительный цикл колеса
(режим ПРОФИЛЬ)
.
- ОТКЛЮЧЕННОМ РЕЖИМЕ
ИЗМЕРЕНИЯ ПРОФИЛЯ,
START.
( , /
).
- АКТИВИРОВАННОМ РЕЖИМЕ
ИЗМЕРЕНИЯ ПРОФИЛЯ,
.
.
F1
F2,
ALU
.
ALU.
ALU
.
F5,
.
(
)
.
7.8.2 Wheel measuring run (PROFILING
mode)
Lower the wheel guard.
- With the PROFILING MEASURING RUN NOT
ACTIVATED,
no signal appears on the screen, therefore to proceed
with the run
press the START button.
The balancer performs the measuring run with the
unbalance measuring cycle and rim profile detection (to
find the type, steel/aluminium and count the spokes, if
present).
- With PROFILING MEASURING RUN
ACTIVATED,
the machine proceeds directly to the measuring run.
At the end of the run, the unbalance values and the points
where the balancing weights should be applied are displayed.
Press F1 and select RIM DATA INPUT.to check the rim
nominal dimensions.
Press F2 to alternate the type of ALU by selecting it from
those suggested. The Menu contains only the ALU that
the machine retains possible, based on the type of rim
detected. At every ALU change the balancer automatically
recalculates the value and position of the weights.
The wheel measuring run may have detected the number
of spokes: in this case press F5 to activate the hidden
weight mode.
Only if it is impossible to read one or more wheel widths
(e.g.: rim without a tyre) the wheel data input screen page
appears automatically, with the values not detected shown
in red.
To Next Page
Loading...