Эксплуатация – АВТОМАТИЧЕСКИЙ РЕЖИМ OPTIMA
Operation - AUTOMATIC “OPTIMA”
КОНТРОЛЬ БИЕНИЙ КОЛЕСА В СБОРЕ
OPTIMA ENTRY F1
Рис. 7-41 :
(Рис. 7-41)
F3
1 .
2 .
3 .
4 1-, 2-, 3-.
.
ПРЕДУПРЕДИТЕЛЬНАЯ ИНДИКАЦИЯ
F4
,
:
(Рис. 7-42)
F4
F4
.
КОНТРОЛЬ БИЕНИЙ ДИСКА
OPTIMA ENTRY F1
Рис. 7-43 :
(Рис. 7-43)
F5
1 .
2 1-, 2-, 3-.
3 3D Plot Sidewall Plot.
“ASSEMBLY RUNOUT INDICATION”
The OPTIMA ENTRY key in the F1 Menu, after the
measuring run of a wheel and tyre, allows access to
the Screen in Fig. 7-41 which contains the following:
(Fig. 7-41)
F3 Menu
1 Access the wheel/rim radial Runout.
2 Access the rim radial/lateral Runout.
3 Access the (data) multi position/harmonic Runout.
4 Access the harmonic 1st, 2nd, 3rd Runout.
For information about the other items and icons, refer to
the basic chapter "Control Elements".
WARNING INDICATION
The F4 Menu key in the Assembly Indication screen, is
used to scroll the messages present, when there are
more than four messages:
(Fig. 7-42)
Press the lower part of the F4 key to scroll down the
list of messages
Press the F4 key upwards to scroll up the list of
messages.
“RIM RUNOUT INDICATION”
The OPTIMA ENTRY key in the F1 Menu in Optima
mode, after a bare rim measuring run, allows access to
the Screen in Fig. 7-43 which contains the following:
(Fig. 7-43)
F5 Menu
1 Go back to the Assembly Indication screen.
2 Access the harmonic 1st, 2
nd
and 3rd Runout.
3 Access the 3D Plot and Sidewall Plot screen.
For information about the other items and icons, refer
to the basic chapter "Control Elements".
To Next Page
Loading...