Эксплуатация – АВТОМАТИЧЕСКИЙ РЕЖИМ OPTIMA
Operation - AUTOMATIC “OPTIMA”
7.10.1.1 Индикатор износа покрышки TDI
OPTIMA
.
(Рис. 7.51):
a) = .
b) = .
c) = .
Примечание:
. TDI
.
(4, Рис.
7.47):
Optima Settings - Tread Depth Limit
(Настройки режима Optima – Предел глубины
протектора)
10 0 OK.
7.10.1.1 TDI Tread Depth Indication
When run in OPTIMA mode, the machine always
automatically detects the depth of the tread groove at the
centre of the tire and over its whole circumference.
According to the mean value detected and the limit value
set, the program displays one of the following Tread
Groove indications on screen (Fig. 7.51):
a) GREEN icon = higher than limit set.
b) YELLOW icon = close to limit.
c) RED icon = below limit set.
Note: The information provided for the operator is
intended as a guideline only. The TDI function
is designed to alert the operator to the need
for a closer examination of wear on the tread.
You can set the tread depth limit value for which wear
information will appear on screen. To change the limit
value go to the Screen (4, Fig. 7.47).
Access the following:
Optima Settings - Tread Depth Limitfinally set the
desired value,
between 10mm and 0mm and press OK.
To Next Page
Loading...