Эксплуатация – АВТОМАТИЧЕСКИЙ РЕЖИМ OPTIMA
Operation - AUTOMATIC “OPTIMA”
RIM ONLY
:
.
F2
(Рис. 7-71).
.
RIM ONLY
,
.
:
= 0.5
= 0.7.
OPTIMA
.
Примечание:
RIM ONLY
"Rim
diagnostic report") (. 9.9).
Примечание:
55 .
Only in the RIM ONLY function, the graph shows three
different coloured markers, indicating the first harmonic
peak position for:
Left bead recess - Yellow triangle
Right bead recess - Red triangle
Mean of the entire rim - Grey triangle
When the rim is turned, it will be stopped by the brake in
each peak position, to facilitate rim marking. The peak
markings on the rim can then be suitably combined with
the minimum reference present on the tyre.
press F2 for further information about the rim Runout
(Fig. 7-71).
These graphs also show the first harmonic peak markers,
combined with the Position Brake.
The "RIM ONLY" diagnosis uses specific limit values,
irrespective of those used for the whole wheel. The factory
values set are:
First harmonic Radial/Lateral Runout = 0.5
Peak to Peak Radial/Lateral Runout = 0.7.
The values can be changed by the user in the "OPTIMA
PARAMETERS" menu.
Note: Activating the "RIM ONLY" function also
allows a specific printed report to be obtained
(if optional printer is present) for the rim only
"Rim diagnostic report" (see Section 9.9).
Note: The function lengthens the measuring cycle to
a total of 55 seconds.
To Next Page
Loading...