Эксплуатация – АВТОМАТИЧЕСКИЙ РЕЖИМ
OPTIMA FULL DIAGNOSTIC
Operation - AUTOMATIC
"OPTIMA FULL DIAGNOSTIC"
F4
(Рис. 7-104):
3 Set of Wheels
OPTI LINE.
Примечание:
,
.
2
.
Примечание: 2,
F3 (Рис. 7-
103).
1
.
"Wheels Currently in the Set".
(Рис. 7-105):
1)
.
2)
.
3)
.
,
•
,
(Рис. 7-106).
The screen page shows new items in the F4 Menu, for
moving backwards in the Set of Wheels procedure (Fig.
7-104):
3 Select to exit the t of Wheels Procedure and the
OPTI LINE Mode.
Nota: If the wheel has not yet been removed from the
balance, you can start a new Set of Wheels
and assign the data of the last wheel, still in
the memory, to the wheel number 1 of the
new Set, without performing the measuring
run.
2 Deletes the current Set and starts a new "Set of
Wheels".
The last wheel examined will be kept and automatically
proposed again as wheel number 1 of the new Set.
Note: Starting with wheel No. 2, the key will be available
for wheel removal, as an alternative to entry
keys F3 (Fig. 7-103).
1 RETURN to the previous step, so that you can assign
the wheel a different use in the Set.
The wheels definitively acquired in the memory are
represented by icons grouped in the "Wheels Currently
in the Set" box. These icons also show any specific
mandatory position assigned as described (Fig. 7-105):
1) Wheel assigned only to left side of vehicle.
2) Wheel available for both sides of vehicle.
3) Wheel assigned only to right side of vehicle.
To continue,
Apply the appropriate identification tag to the wheel
valve, with the same number and colour as the last
wheel shown (Fig. 7-106).
To Next Page
Loading...