Эксплуатация – АВТОМАТИЧЕСКИЙ РЕЖИМ
OPTIMA FULL DIAGNOSTIC
Operation - AUTOMATIC
"OPTIMA FULL DIAGNOSTIC"
Ввод нового комплекта колес
.
:
•
1.
.
.
:
•
.
•
.
•
.
•
.
•
Set of Wheels
F5 (1, Рис. 7-102).
5 (Рис. 7-114).
•
2 F4 (Рис. 7-114).
.
Завершение процедуры и выход из нее
Set of Wheels
OPTIMA ENTRY.
•
F4 3 (Рис. 7-115).
.
Start a new Set of Wheels
After entry of WHEEL No. 5 in a Set, you can start a new
Set, without exiting the Set of Wheels mode. Proceed as
follows:
Perform the procedure as described for wheelNo. 1.
The machine deletes the data relative to the previous wheels
and shows the current wheel as the first wheel in a new
Set.
After entry of WHEEL No. 4 in a Set you can start a new
Set, without exiting the Set of Wheels mode. Proceed as
follows:
Mount the wheel on the balancer shaft.
Perform the run.
Complete any normal correction and balancing
operations required.
Remove the wheel from the balancer.
Access the t of Wheels screen from the F5
Menu (1, Fig. 7-102).
Wheel number 5 is shown on the screen page (Fig. 7-114).
Select Item 2 from the F4 Menu (Fig. 7-114).
The machine deletes the data relative to the previous wheels
and shows the last wheel as wheel number 1, starting a
new Set of Wheels.
Terminate and exit procedure
To exit the Set of Wheels procedure and return to the
OPTIMA ENTRY screen page.
Press key F4 and select Item 3 (Fig. 7-115). All data
relative to the Set of Wheels is deleted.
To Next Page
Loading...