Отпимизация / минимизация
Optimisation/ Weight minimisation
9.3 Запуск программы оптимизации/
минимизации
•
( 6.5)
.
•
(
),
.
• ( 7.1.1).
• ( 7).
• .
• F1
1 (Рис. 9-1).
(Рис. 9-2).
.
Запуск программы оптимизации
• F4
(1, Рис. 9-2a).
(Рис. 9-4).
9.3.2.
Запуск программы минимизации
• F4
(1, Рис. 9-2b).
(Рис. 9-5).
• 9.3.1.
Возобновление программы оптимизации /
минимизации
Примечание:
F1 (Рис.
9-4).
F3.
.
•
.
• F3.
.
•
.
9.3 Start optimisation/weight minimisation
• To perform a Minimisation run correctly clamp a
complete wheel (Section 6.5) or just the rim for an
Optimisation run.
• For a MINIMISATION run, check that the tyre is
correctly mounted on the rim (Axial run-out test)
and that it is pumped up to the set pressure.
• Select the Vehicle Type (Section 7.1.1).
• Read the rim dimension parameters (Chapter 7).
• Launch a Measuring run.
• On the BALANCING screen press the F1 Menu key,
and then select the Optimisation item (1, Fig. 9-1).
The OPTIMISATION screen (Fig. 9-2) is displayed.
You can now start the procedure as follows.
Start weight optimisation
• Press the F4 Menu key and then select the Start
Optimisation item (1, Fig. 9-2a).
The OPTIMSATION 1 screen (Fig. 9-4) is displayed.
Continue as described in Chapter 9.3.2.
Start weight minimisation
• Press the F4 Menu key and then select the Start
Minimisation item (1, Fig. 9-2b).
The MINIMISATION 1 screen (Fig. 9-5) is displayed.
• Proceed from the MINIMISATION 1 item as described
in Chapter 9.3.1.
Recalling Optimisation/ Minimisation
Note:
If a previously interrupted Optimisation/Minimisation
run is in the memory, when the Optimisation item is
selected from the F1 Menu, the OPTIMISATION screen
(Fig. 9-4) is displayed.The interrupted cycle can be
restarted using the F3 Menu key. The program will
proceed from exactly the point at which is was
interrupted.
• Clamp the wheel removed previously when the
Optimisation/Minimisation run was interrupted.
• Press the menu key F3.
The screen in which optimisation/weight minimisation was
previously interrupted is displayed.
• Proceed according to the current programme stage.
To Next Page
Loading...