Отпимизация / минимизация
Optimisation/ Weight minimisation
9.3.1 Цикл минимизации
Рис. 9-6 1
()
•
.
•
F4 (Рис. 9-6).
2 (Рис.
9-7).
Рис. 9-7 2
START
.
•
F5.
•
START.
.
•
9.5).
9.3.1 Minimisation Cycle
Fig. 9-6 MINIMISATION 1
(First measuring run of tyre/rim assembly)
• Position the valve exactly perpendicular to and above
the wheel holder shaft.
• Enter the valve position by pressing menu key F4
(Fig. 9-6).
The MINIMISATION 2 screen (Fig. 9-7) is displayed.
Fig. 9-7 MINIMISATION 2
START? is signalled on the screen.
• If necessary, go back by pressing menu key F5.
• Close the wheel guard and press the START key.
A measuring run is performed.
• Next proceed as for optimisation, starting at the
screen as shown in 9.5.
To Next Page
Loading...