Отпимизация / минимизация
Optimisation/ Weight minimisation
Рис. 9-16 10,
•
.
•
двойную отметку
внешней .
Примечание:
F5.
• F4 .
11 (Рис. 9-18).
Рис. 9-17 10,
Вариант 1: БЕЗ ПОВОРОТА ПОКРЫШКИ
:
• F4 "NOT TURNED OVER"
( ) (1, Рис. 9-17a);
10
(Рис. 9-16),
.
Вариант 2: ПОВОРОТ ПОКРЫШКИ
:
• F4 "CONFIRM"
() (2, Рис. 9-17a)
.
•
•
двойную отметку
внутренней .
Примечание:
F5.
• F4 .
11 (Рис. 9-19).
Рис. 9-18 11
• ,
.
• F4 .
12 (Рис. 9-20).
Fig. 9-16 OPTIMISATION 10, outside
• Rotate the wheel into marking position following the
arrows.
• In this position mark a double notch on the
outside of the tyre exactly on the wheel holder
shaft.
Note
The F5 key allows you to move back a step.
• Confirm by pressing menu key F4.
The OPTIMISATION 11 screen (Fig. 9-18) is displayed.
Fig. 9-17 OPTIMISATION 10, inside
Option 1: TYRE NOT TURNED OVER
If the tyre must not be turned over on the rim:
• Press the F4 Menu key to select the "NOT TURNED
OVER" item (1,Fig. 9-17a); the machine will re-
propose "OPTIMISATION 10, external" (Fig. 9-16) and
the operator can continue following the indications in
the previous step.
Option 2: TYRE TURNED OVER
If the tyre is turned over on the rim:
• Press the F4 Menu key to select the "CONFIRM" item
(2,Fig. 9-17a) and continue as follows.
• Turn the wheel to the position marked by the notch
(green direction arrows)
• In this position mark a double notch on the inside
of the tyre exactly perpendicular to the wheel holder
shaft.
Note:
The F5 key allows you to move back a step.
• Confirm by pressing menu key F4.
The OPTIMISATION 11, turn screen (Fig. 9-19) is
displayed.
Fig. 9-18 OPTIMISATION 11
• Using the tyre-changer, push the tyre along the
rim until the double notch and the valve on the rim
are in line with the valve.
• Confirm by pressing menu key F4.
The OPTIMISATION 12 screen (Fig. 9-20) is displayed.
To Next Page
Loading...