Отпимизация / минимизация
Optimisation/ Weight minimisation
Рис. 9-19 11,
• .
•
.
•
.
• F6 .
12 (Рис. 9-20).
Рис. 9-20 12
()
• .
•
.
• F6,
.
13 (Рис. 9-21).
Рис. 9-21 13
START
.
Примечание:
F5.
• START.
.
14 (Рис. 9-22).
Fig. 9-19 OPTIMISATION 11, turn
• Remove the wheel from the balancer.
• Using the tyre-changer, turn the tyre over on the
rim.
• Push the tyre along the rim until the double notch
and the valve on the rim are in line with the valve.
• Confirm by pressing menu key F6.
The OPTIMISATION 12 screen (Fig. 9-20) is displayed.
Fig. 9-20 OPTIMISATION 12
(4th measuring run of tyre/rim assembly)
• Clamp the wheel on the balancer.
• Position the valve so it is exactly perpendicular to
the wheel holder shaft.
• Confirm the valve position by pressing menu key F6.
The OPTIMISATION 13 screen (Fig. 9-21) is displayed.
Fig. 9-21 OPTIMISATION 13
START? is displayed on the screen.
Note:
The F5 key allows you to move back a step.
• Close the wheel guard and press START.
A measuring run is performed.
The OPTIMISATION 14 screen (Fig. 9-22) is displayed.
To Next Page
Loading...