* = Factory adjusted mode
Запуск измерительного цикла закрытием
защитного кожуха
Disabled* = START
Enabled =
.
Автоматическое торможение колеса при
поднятии защитного кожуха
Disabled =
ВНИМАНИЕ: ПРИ ПОДНЯТОМ КОЖУХЕ КОЛЕСО
ПРОДОЛЖАЕТ ВРАЩАТЬСЯ.
УБЕДИТЕСЬ, ЧТОБЫ КОЛЕСО НЕ БЫЛО
ЗАБЛОКИРОВАНО ИНСТРУМЕНТОМ ИЛИ
ДРУГИМИ ПРЕДМЕТАМИ.
НОСИТЕ ЗАЩИТНЫЕ ОЧКИ И ПЛОТНО
ПРИЛЕГАЮЩУЮ РАБОЧУЮ ОДЕЖДУ.
Enabled * =
.
Настройка ДАТЫ/ВРЕМЕНИ
,
ПРОКРУТКИ.
F2 F3.
Дата: День
: .
Дата: Месяц
: .
Дата: Год
: .
Время: Час
: .
Время: Минуты
: .
Примечание:
.
Starting the mesuring run by closing the
wheel guard
Disabled* = Start via START key
Enabled = Start via wheel guard
The selected mode of operation can be transferred
to the permanent memory.
Automatic braking when the wheel guard is
raised
Disabled =No braking
WARNING: WHEN THE GUARD IS LIFTED, THE
WHEEL IS NOT BRAKED AND CONTINUES TO
ROTATE FROM INERTIA.
MAKE SURE THAT THE WHEEL IS NOT BLOCKED BY
A TOOL OR SIMILAR ITEM.
WEAR SAFETY GOGGLES AND TIGHTLY FITTING
WORKING CLOTHES.
Enabled * = Braking
The selected mode of operation can be transferred
to the permanent memory.
Adjusting the DATE/TIME COUNTERS
The flashing cursor in the Values panel identifies the
character that can be changed at that moment using the
SCROLL command.
You can move backwards and forwards in the date and
time fields using the F2 & F3 commands.
Date: Day
Actual date: selection of the day.
Date: Month
Actual date: selection of the month.
Date: Year
Actual date: selection of the year.
Time: Hour
Actual time: selection of the hour.
Time: Minute
Actual time: selection of the minute.
Note:
Changes to the date and time are immediately
activeand are retained when the machine is next
startedwithout needing to be saved to the
permanentmemory.
To Next Page
Loading...