Текстовое поле
.
A Z.
•
.
• F3
,
.
Примечание:
F2
.
•
(1, Рис. 10-4b) F5,
.
Пример ввода текста
.
:
Garage - 1
(3, Рис. 10-4),
:
•
"G".
• F3
.
• F4
(1, Рис.
10-4a), OK.
• "a".
• F3.
• F4 (1).
• "r".
• F3.
• F4 (1)..
• "a".
• F3.
• F4 (1).
• "g".
• F3.
• F4 (1).
• "e".
• F3.
•
( A Z).
• F3.
• F4
(4, Рис. 10-4a).
Text field
The text field has five lines of 25 characters each.
The spaces between words must be filled with blanks
that are located between the Upper Case and Lower Case
letter A and Z.
• Use the SCROLL to select the character you wish to
insert.
• Using the F3 key, then move the cursor to the right
by one position, insert another letter and continue like
this until the text is complete.
Note:
The F2 key allows you to move the cursor back if you
need to return to a previous character.
• At the end of the current line, select the tick sign (1,
Fig. 10-4b) in Menu F5, to save the message .
Example of how to enter a text
We suggest that you write the text down on a piece of
paper first so you can count the number of characters
and have a draft to follow when entering text.
For example to enter the following text:Garage - 1
Once you have accessed the Values field (3, Fig. 10-4)
proceed as follows:
• Use the SCROLL command to reach the first letter
"G" in this example.
• Press the F3 key to move to the next position in the
message to be written.
• Press the F4 key and using the SCROLL command
select the type of Lower Case letter (1, Fig. 10-4a),
and confirm by pressing OK.
• Using the SCROLL command select the letter "a".
• Press F3.
• Press F4 and select the Lower Case letter (1).
• Using the SCROLL command select the letter "r".
• Press F3.
• Press F4 and select the Lower Case letter (1).
• Using the SCROLL command select the letter "a".
• Press F3.
• Press F4 and select the Lower Case letter (1).
• Using the SCROLL command select the letter "g".
• Press F3.
• Press F4 and select the Lower Case letter (1).
• Using the SCROLL command select the letter "e".
• Press F3.
• Using the SCROLL select the space " "(between letter
A and letter Z).
• Press F3.
• Press F4 and select Special Letters (4, Fig. 10-4a).
.
To Next Page
Loading...