H80
.
.
• STOP ESC
.
•
.
H82
(
).
• 3 ,
(. 10 )
STOP ESC.
H90
.
:
• .
•
.
•
START.
•
.
H91
.
.
• .
•
.
• .
H948
H949
.
.
Примечание:
.
• .
•
.
H80
Readjustment feature not foreseen during basic
calibration. Consequently readjustment by the operator
is not possible.
• Press on STOP or ESC key, error code is deleted.
• Call service for calibration of the machine.
H82
The self-test was disturbed (e.g. by rotating the wheel).
• The message is displayed for 3 seconds, after which
the measurement is repeated (max. 10 times), or
aborted by pressing the STOP or ESC key.
H90
The wheel was accelerated too slowly or decelerated too
slowly after a measuring run.
If the main shaft does not reach the required speed, check
whether the wheel shaft lock is actuated or whether the
weight of the wheel is excessive.In this case:
• Release main shaft lock.
• Make sure that the shaft with clamped wheel can
rotate freely.
• Turn the wheel by hand and then press on START
key.
• If the error cannot be remedied: call service.
H91
Speed variations during measuring run. The main shaft
lock may be operated.
• Release main shaft lock.
• Make sure that the shaft with clamped wheel can
rotate freely.
• Repeat the measuring run.
H948
H949
Fault during self-test at start-up.
The firmware is not aligned with the User Interface version
currently in use.
Note:
Wheel balancer operation is not compromised.
• You can continue using the machine.
• Consult the technical assistance department for
further information.
To Next Page
Loading...