Коды критических ошибок
6-
- .
300XXX,
C10XXX
.
• .
300 800 C10 800
170 .
,
.
.
• 200 -
230- 240
(. 6705 902).
300 801 или C10 801
265 .
!
• !
• 200 -
230- 240
(. 6705 902).
.
300 804 C10 804
275 .
!
• !
• 200 -
230- 240
(. 6705 902).
.
Звуковые сообщения об ошибках
.
( )
.
• .
• .
Fatal error codes
The display shows an alphanumeric code consisting of
six digits and/or letters. When messages are read out
starting 300XXX the error occurred during the internal
operational check, if it is C10XXX it occurred during the
selftest after the machine was switched on.
• If necessary, call service.
300 800 or C10 800
Line voltage under 170 V. Balancing is feasible if the motor
can drive the main shaft to the measuring speed. Wheel
data may be lost.
• Bring the line voltage to within a range of 200 - 230
- 240 Volts with an input transformer (ref. 6705 902).
300 801 or C10 801
Line voltage over 265 V. Damage to the electronic unit of
the machine is likely!
• Turn off mains switch!
• Bring the line voltage to within a range of 200 - 230
- 240 Volts with an input transformer (ref. 6705 902).
Any damage resulting from repeated occurrence of this
error code is not covered by the guarantee.
300 804 or C10 804
Line voltage over 275 V. Damage to the electronic unit of
the machine is likely!
• Turn off mains switch.
• Bring the line voltage to within a range of 200 - 230
- 240 Volts with an input transformer (ref. 6705 902).
Any damage resulting from repeated occurrence of this
error code is not covered by the guarantee.
Error messages by means of acoustic signals
Error messages can also be indicated by means of
acoustic signals. The service technician can locate and
eliminate the corresponding error by means of the number
of tones, their frequency and duration (long/short) and
the length of the pauses.
• Switch off the machine.
• Call service.
To Next Page
Loading...