ВВОД ДАННЫХ ДИСКА
F1 (Рис. 4-6):
1
2
3
4 (HOME)
F2 ALU
(
):
5 ALU 0
6 ALU 1
7 ALU 2
8 ALU 3
9 ALU 4
10 ALU 5
ALU ALU P.
F3 :
11
12
13
14
F4:
15 Easy Alu Toggle
F5:
16
17 /
18 ()
НАСТРОЙКИ - ФУНКЦИИ
F1 (Рис. 4-7):
1
2
3
4 (HOME)
F3 (5)
b c,
a
5 b c
F6
:
6
7
RIM DATA INPUT
The F1 Menu in the Rim Data Input screen (Fig. 4-6), contains
the following items:
1 Access to BALANCING
2 Access to OPTIMISATION
3 Access to SETTINGS
4 Go back to the START SCREEN (HOME)
The F2 menu contains the different ALU selection items
(enabled if in manual mode or after the measurement run):
5 ALU 0 Selection
6 ALU 1 Selection
7 ALU 2 Selection
8 ALU 3 Selection
9 ALU 4 Selection
10 ALU 5 Selection
Each Menu Item enables the selection for ALU and ALU P.
The F3 menu contains the following items to select the Type
of Vehicle settings:
11 CAR Selection
12 SUV Selection
13 VAN Selection
14 MOTORCYCLE Selection
The F4 Menu contains the following items:
15 Easy Alu Toggle Selection
The F5 Menu contains the following items:
16 WHEEL PROFILE Input
17 MILLIMETRES / INCHES Selection
18 WEIGHTS MOVEMENT Selection (in MANUAL only)
SETTINGS - FUNCTIONS
The F1 Menu in the Functions screen (Fig. 4-7), contains the
following items:
1 Access to BALANCING
2 Access to RIM DATA INPUT
3 Access to OPTIMISATION
4 Go back to the START SCREEN (HOME)
The F3 (5) key in the Functions screen, is used to access the
b and c panels used to select and change the options shown
in the basic list a
5 Alternate selection of panels b and c
The F6 Menu of the Functions Screen contains the Items to
access the following procedures:
6 Access to COMPENSATION RUN
7 Access to USER CALIBRATION
To Next Page
Loading...