ОПТИМИЗАЦИЯ/ МИНИМИЗАЦИЯ
/ (Рис. 4-8)
.
.
F4.
ПРОФИЛЬ КОЛЕСА ()
(Рис. 4-9)
.
.
F6 :
1, Рис. 4-9
OK
.
ТЕКСТОВЫЙ РЕДАКТОР
(Рис. 4-10)
.
Общие параметры.
F3 панели и
OK ( 1),
( 2), ( 3), ( 4) ( 5).
.
F4
-
F2/ F3.
OK, F3
.
.
OPTIMISATION/ MINIMIZATION
The Optimisation /Minimization Menu (Fig. 4-8), is used to
perform the relative procedure for the wheels being worked.
An operational sequence, and control screens, guide the user
through the entire operation.
The F4 key is used to advance the procedure.
WHEEL PROFILES (in MANUAL only)
The Wheel Profiles item (Fig. 4-9) is recalled from the Rim
Data Input Menu.
It is used to memorize and recall from a list, complete wheel
data settings.
The F6 Menu in the Rim Data Input screen with the item:
1, Fig. 4-9 Access to LIST OF WHEEL PROFILES
The desired wheel profile can be selected form the List screen,
by scrolling the available Items with the Cursor. Press OK to
activate the selection.
TEXT COMPOSITION
The Text Composition (Fig. 4-10), is used to set and memorise
a five line text in the Start screen.
The text composition is performed directly in the Settings
screen, at the General settings item.
Press F3 to access the central panel in order to select with
the OK key, one of the five lines available (line 1), (line 2),
(line 3), (line 4) and (line 5).
In the panel on the right an underscore identifies the writing/
change position on the line.
Use the Cursor to select the font to input.
Press F4 to select the type of font and F2/ F3 to move right or
left along the line.
Press OK and then F3 to input the text and move to the next
line. Select another line and proceed in the same way.
To Next Page
Loading...