5.2 Коды сообщений об ошибках при включении
STOP ESC.
.
:
Глубой экран
.
E3
.
.
STOP ESC.
E4
.
.
STOP ESC.
E89
.
.
:
STOP ESC
.
,
STOP ESC.
.
E92
. .
3 .
STOP ESC .
E93
.
.
3 .
STOP ESC .
E145
.
5.2 Error codes at power on
If an error code occurs it must be acknowledged by
pressing the STOP key or ESC key. No audible signal is
given.
The following malfunction codes may occur at power-on:
Blue Screen
The communication between the microcontroller and
em-bedded PC is interrupted.
Check connecting lead
E3
The gauge arm for distance and rim diameter is not in
home position.
Move gauge arm to its home position. Press the
STOP key or the ESC key.
E4
The width gauge arm is not in home position.
Move gauge arm to its home position. Press the
STOP key or the ESC key to continue.
E89
A key is jammed or the pedal switch is closed.
Find and release jammed key.
Or:
Press STOP or ESCkey to check the switch.
If the error cannot be remedied, the pedal function is switched
off by pressing the STOP key or the ESC key. Call service.
E92
During the second attempt the gauge arm for distance
and rim diameter was still not in the home position.
Both gauge arms are rendered inoperative.
Wait 3 seconds, or press the STOP key or the
ESC key to continue.
E93
During the second attempt the width gauge arm was still
not in the home position. The gauge arm is rendered
inoperative.
• Wait for 3 seconds, or press the STOP key or the
ESC key.
E145
The contents of both permanent memories are
different, but both contain valid data.
To Next Page
Loading...