H82
(
). ,
(. 10 )
STOP ESC.
H948
H949
.
.
Примечание:
.
• .
•
.
Коды критических ошибок
6-
- .
C10 800
170 .
.
.
• 200
230 - 240
(. 6705 902).
C10 801
265 .
!
• !
• 230
-
(. 6705 902).
.
C10 804
275 .
!
• !
• 230 -
(. 6705 902).
.
H82
The selftest was disturbed (e.g. by rotating the wheel).
The message is displayed for 3 seconds, after which the
measurement is repeated (max. 10 times), or aborted by
pressing the STOP key or the ESC key.
H948
H949
Fault during self-test at start-up.
The firmware is not aligned with the User Interface version
currently in use.
Note:
Wheel balancer operation is not compromised.
You can continue using the machine.
Consult the technical assistance department for
further information.
Fatal error codes
The selftest program has detected an error and displays
a alphanumeric code consisting of six digits and/or letters.
C10 800
Line voltage under 170 V. Balancing is feasible if the motor
can drive the main shaft to the measuring speed. Wheel
data may be lost.
Bring the line voltage to within a range of 200 - 230
- 240 Volts with an input transformer (ref. 6705 902).
C10 801
Line voltage over 265 V. Damage to the electronic unit of
the machine is likely!
Turn off mains switch!
Bring the line voltage to within a range of 200 - 230
- 240 Volts with an input transformer (ref. 6705 902).
Any damage resulting from repeated occurrence of this
error code is not covered by the guarantee.
C10 804
Line voltage over 275 V. Damage to the electronic unit of
the machine is likely!
Turn off mains switch!
Bring the line voltage to within a range of 200 - 230
- 240 Volts with an input transformer (ref. 6705 902).
Any damage resulting from repeated occurrence of this
error code is not covered by the guarantee.
To Next Page
Loading...