Руководство по эксплуатации
7.3.1 Ввод типа транспортного средства
1.
.
• F3 (Рис. 7-11)
(Рис. 7-10).
• .
Fig. 7-11
:
1
.
- (inch).
Alu1Alu5.
TD TRX), mm/inch
(мм/дюйм) F5
Рис. 7-10.
2
дюймах (inch).
3 () -
дюймах (inch).
"Product Requisite"
.
10 5
.
WeightMiser 1,5
(
Weight Miser).
4
.
"Product Requisite.
(Рис. 7-12).
7.3.1 Selecting the Type of Vehicle
When the unit is started it shows the "Vehicle" selection 1.
In MANUAL mode the vehicle must always be selected
by the operator.
On the BALANCING and RIM DATA ENTRY screen
Fig. 7-10 press the menu key F3 Fig. 7-11 to select
the Type of Vehicle.
Select the TYPE OF VEHICLE item according to the
rim on the machine.
Fig. 7-11 Types of Vehicle
Assigned Menu items:
1 Standard vehicle wheel (car)- nominal dimensions in
inches.The unit of measure (inches) is displayed.
Normal and Alu 1 to Alu 5 weight positioning can be
selected. To select a standard wheel with nominal
dimensions in mm - TD or TRX wheel, you should select
the mm/inch option from Menu F5 in the RIM DATA
ENTRY screen Fig. 7-10.
2 SUV vehicle wheel - nominal dimensions in inches.
3 Light industry vehicle wheel (Van) - nominal dimensions
in inches. Executable steps are expressed in the
"Product Requisite" table at the end of the manual.
The threshold value for suppression of minor unbalances
is automatically doubled when this type is chosen and
the resolution of the amount reading set to 10 g and 5
g respectively. Thresholds for WeightMiser correspond
to 1.5 times this value (see specific Weight
user's handbook).
4 Motorcycle wheel - nominal dimensions in inches, with
imbalances resolved and suppressed in the same way
as car wheels. Consult executable steps in the
"Product Requisite" table.
When the selection has been made, a Type of Vehicle
in use identification icon will be displayed in the Status
Bar at top left Fig. 7-12.
To Next Page
Loading...