Руководство по эксплуатации
7.3.2 Ручной выбор режима ALU
• F2 (Рис. 7-14)
(Рис. 7-10).
• ALU
.
Рис. 7-14 ALU
F2:
1 ALU 0 ()
.
2 ALU 1 -
.
3 ALU 2 -
.
4 ALU 3 -
,
.
5 ALU 4 -
-
.
6 ALU 5 -
- .
ALU
(Рис. 7-13)
.
7.3.2 Manual ALU selection
On the BALANCING and ENTERING RIM DATA screen
(Fig. 7-10) press the F2 MENU key (Fig. 7-14) to
select a specific ALU mode.
Select the ALU item corresponding to the required
weight location.
Figure 7-14 ALU types
Assigned F2 Menu items:
1 ALU 0 (normal) - Using clip-on weights on the internal
and external sides of the rim.
2 ALU 1 - Using adhesive weights on the internal and
external rim flange.
3 ALU 2 - Using an adhesive weight on the internal rim
flange and an adhesive weight on the rim disc. Both
weights will be invisible from the outer wheel.
4 ALU 3 - Using a clip-on weight on the inside and an
adhesive weight on the rim disc. Both weights will be
invisible from the outer wheel.
5 ALU 4 - Using a clip-on weight on the inside and an
adhesive weight on the external rim flange.
6 ALU 5 - Using an adhesive weight on the internal rim
flange and a clip-on weight on the outside of the rim.
A Type of ALU in use identification icon Fig. 7-13 will be
displayed in the Status Bar at top left.
To Next Page
Loading...