Руководство по эксплуатации
7.3.3 Ручной ввод данных диска
Easyalu .
( )
(Alu P).
• F5
(1,
Рис. 7-15).
7.3.3.1 Ввод ширины диска
- (Рис. 7-16 - .
EAA0247G21A).
:
•
.
• F3 (2, Рис. 7-17)
.
• F3
.
7.3.3.2 Ввод расстояния от станка до диска
.
Рис. 7-18
X
A 5 X
A.
• X (Рис. 7-18)
.
A = X 5 .
• F2 (1, Рис. 7-17)
.
• F2 .
7.3.3.3 Ввод диаметра диска
,
.
•
.
• F4 (3, Рис. 7-17)
.
• F4 .
7.3.3 Entering rim measurements manually
Entering rim measurements manually results in
balancing cycles based on nominal data outside of the
Easyalu function.
If data is changed manually, before or after a run, the
system immediately exits the automatic function and
inhibits real data based measurements (Alu P).
• Access the ENTERING RIM DATA screen and select
the EDIT MEASUREMENTS item (1, Fig. 7-15) by
selecting the Menu key F5.
7.3.3.1 Entering the rim width
If the width of the rim cannot be measured, if a standard
rim is present it can be measured using the width gauge
(Figure 7-16 - reg. no. EAA0247G21A).
To set rim width:
• Measure the width with the appropriate gauge or read
the data stamped on the wheel.
• Press the menu key F3 (2, Figure 7-17) and scroll
until the required value is reached.
• Press the menu key F3 to set the value.
7.3.3.2 Entering the rim/machine distance
If automatic determination of the distance rim/machine is
not possible (error code E 92), the distance can be
determined manually.
Fig. 7-18 Determining distance by measurement
X Distance between cabinet cover edge and rim
A Value X (as measured) less 5 mm = Value A to be
entered.
• Measure the distance X (Fig. 7-18) between cabinet
cover edge and rim.
The value A to be inserted corresponds to X less 5mm.
• Press the menu key F2 (1, Figure 7-17) and scroll
until the required value is reached.
• Press the menu key F2 to set the value.
7.3.3.3 Entering the rim diameter
If automatic determination is not possible (error code E92),
therim diameter can be determined manually .
• Read the nominal diameter on the rim or tyre and
note it down.
• Press the menu key F4 (3, Fig. 7-17) and scroll until
the required value is reached.
• Press the menu key F4 to set the value.
To Next Page
Loading...