Руководство по эксплуатации
7.5.1 Сохранение профиля колеса
.
•
.
•
,
EasyAlu, Easy Alu Toggle
Alu P.
• F6
(1, Рис.
7-23).
(Рис. 7-24).
.
• 9
• F3 .
, ,
.
Примечание:
.
7.5.2 Использование сохраненного профиля
колеса
• .
• F6
(1,
Рис. 7-23).
(Рис. 7-24).
•
.
• F5 .
(Рис. 7-
25) .
•
.
( 8.1).
7.5.1 Saving a Wheel Profile
Up to 9 wheel profiles can be saved.
• Clamp the wheel you wish to save the profile of.
• Set and acquire all the wheel data including the number
of spokes and the EasyAlu and Easy Alu Toggle
readings if an Alu P is required.
• Press the menu key F6 in the ENTERING RIM DATA
screen and select the Wheel Profiles item (1, Fig. 7-
23).
The WHEEL PROFILES screen (Fig. 7-24) will open.
The current wheel profile data is highlighted in a line on
its own at the bottom of the page.
• In the 9 position list, use the Scroll command to
choose the current profile registration position.
• Press the F3 key to save data.
The data is now saved permanently in the chosen position
and can be recalled when required.
Note:
If the profile is overwritten with other data it is no longer
shown in the list.
7.5.2 Recalling a Wheel Profile from the
memory
• Clamp the wheel to the balancer.
• Press the Menu key F6 in the ENTERING RIM DATA
screen and then select and press the WHEEL
PROFILES key (1, Fig. 7-23).
The WHEEL PROFILES screen (Fig. 7-24) will open.
• Use the Scroll command to select the profile indicated
for the wheel on the machine.
• Press the F5 key to apply the data selected.
The ENTERING RIM DATA screen (Fig. 7-25) will open
and show the data recalled.
• Check that the settings in the Indications Field and
Status Bar panel are correct.
The machine is now ready to proceed with the measuring
run (Chapter 8.1).
To Next Page
Loading...