FX-3R Maintenance Guide
10-6
1) Detach the switch panels from the front and rear sides. (Front, screws at 2 locations, Inside of
cover, screws at 2 locations)
2) Detach the operation board.
3) To detach the switch, remove the root part (mounting nut) of the switch from the back of the
cover and pull out the case from the cover surface.
4) Reassemble the components in the reverse order of disassembly.
Turn.
Turn.
Mounting
nut
Edge
Panel
Case
Groove
Pull out.
Stop metal fitting
Figure 10-4-3 Back of Cover Figure 10-4-4 Detaching the Switch
∗ The list of replacement parts is described in section 13-9-3.
A combination of the switch connector and connector on the operation switch board has
a specified orientation. Always pay special attention to the orientation when mounting
the switch.
CAUTION
Rev. 1.00
To Next Page
Loading...
