This procedure connects the router to the network but does not enable it to forward
traffic. For complete information about enabling the router to forward traffic, including
examples, see the Junos OS configuration guides.
To configure the software:
1. Verify that the router is powered on.
2. Log in as the “root” user. There is no password.
3. Start the CLI.
root# cli
root@>
4. Enter configuration mode.
cli> configure
[edit]
root@#
5. Configure the name of the router. If the name includes spaces, enclose the name in
quotation marks (“ ”).
[edit]
root@# set system host-name host-name
6. Create a management console user account.
[edit]
root@# set system login user user-name authentication plain-text-password
New password: password
Retype new password: password
7. Set the user account class to super-user.
[edit]
root@# set system login user user-name class super-user
8. Configure the router’s domain name.
[edit]
root@# set system domain-name domain-name
9. Configure the IP address and prefix length for the router’s Ethernet interface.
[edit]
root@# set interfaces fxp0 unit 0 family inet address address/prefix-length
10. Configure the IP address of a backup router, which is used only while the routing
protocol is not running.
Copyright © 2017, Juniper Networks, Inc.118
ACX1000 and ACX1100 Universal Access Router
To Next Page
Loading...
Need help?
General
