Juniper ACX1000 User Manual

Supported Network Interface Standards by Transceiver for ACX Series, M Series, MX
Series, and T Series Routers
Table 27 on page 69 and Table 28 on page 75 list the transceivers supported by ACX, M,
MX, and T Series devices.
NOTE: Not all transceivers are supported on all devices. To determine which
transceivers are supported in a particular device, see the “Cables and
Connectors” section for each PIC, MIC, or line card in the Interface Module
Reference for your device, or see the Hardware Compatibility Tool.
TIP: You can use the Hardware Compatibility Tool to find information about
the pluggable transceivers supported on your Juniper Networks device.
•
Table 27 on page 69 lists the supported Ethernet standards for each transceiver.
•
Table 28 on page 75 lists the supported SONET standards for each transceiver.
Some transceivers support monitoring by using the operational mode CLI command
show interfaces diagnostics optics. To determine which transceivers support monitoring,
refer to the “Monitoring Available” column in Table 27 on page 69 and Table 28 on page 75.
For a description of the monitoring fields displayed by the transceiver, see show interfaces
diagnostics optics (Gigabit Ethernet, 10-Gigabit Ethernet, 40-Gigabit Ethernet, 100-Gigabit
Ethernet, and Virtual Chassis Port) or show interfaces diagnostics optics (SONET).
CAUTION: If you face a problem running a Juniper Networks device that uses
a third-party optic or cable, the Juniper NetworksTechnical Assistance Center
(JTAC) can help you diagnose the source of the problem. Your JTAC engineer
might recommend thatyou check the third-party optic or cable and potentially
replace it with an equivalent Juniper Networks optic or cable that is qualified
for the device.
NOTE: For XFP transceivers that can support either the 10-Gigabit Ethernet
or SONET OC192/STM64 specifications, check the standard supported for
the device into which the transceiver is installed. For example, the
XFP-10G-E-OC192-IR2 transceiver installed in a 10-Gigabit Ethernet PIC
supports the 10GBASE-E standard. However, the XFP-10G-E-OC192-IR2
transceiver installed in a SONET OC192/STM64 PIC supports the SONET
OC192/STM64 IR2 standard.
Table 27 on page 69 is organized by transmission speed and then alphabetically by model
number.
Copyright © 2017, Juniper Networks, Inc.68
ACX1000 and ACX1100 Universal Access Router

Juniper ACX1000 Specifications

General

Brand	Juniper
Model	ACX1000
Category	Network Router
Language	English