Advarsel Før det utføres arbeid på kabinettet eller det arbeides i nærheten
av strømforsyningsenheter, skal strømledningen trekkes ut p
vekselstrømsenheter og strømmen kobles fra ved strømbryteren på
likestrømsenheter.
Aviso Antesde trabalhar num chassis,ou antesde trabalhar pertode unidades
de fornecimento de energia, desligue o cabo de alimentação nas unidades
de corrente alternada; desligue a corrente no disjuntor nas unidades de
corrente contÃnua.
¡Atención! Antes de manipular el chasis de un equipo o trabajar cerca de una
fuente de alimentación, desenchufarel cable de alimentación en los equipos
de corriente alterna (CA); cortar la alimentación desde el interruptor
automático en los equipos de corriente continua (CC).
Varning! Innan du arbetar med ettchassi eller nära strömförsörjningsenheter
skall du för växelströmsenheter dra ur nätsladden och för likströmsenheter
bryta strömmen vid överspänningsskyddet.
Related
Documentation
DC Power Electrical Safety Warnings for Juniper Networks Devices on page 188•
General Electrical Safety Guidelines and Electrical Codes for Juniper Networks Devices
•
Install the router in compliance with the following local, national, or international
electrical codes:
•
United States—National Fire Protection Association (NFPA 70), United States
National Electrical Code.
•
Canada—Canadian Electrical Code, Part 1, CSA C22.1.
•
Other countries—International Electromechanical Commission (IEC) 60364, Part 1
through Part 7.
•
Locate the emergency power-off switch for the room in which you are working so that
if an electrical accident occurs, you can quickly turn off the power.
•
Do not work alone if potentially hazardous conditions exist anywhere in your workspace.
•
Never assume that power is disconnected from a circuit. Always check the circuit before
starting to work.
•
Carefully look for possible hazards in your work area, such as moist floors, ungrounded
power extension cords, and missing safety grounds.
•
Operate the router within marked electrical ratings and product usage instructions.
•
For the router and peripheral equipment to function safely and correctly, use the cables
and connectors specified for the attached peripheral equipment, and make certain
they are in good condition.
185Copyright © 2017, Juniper Networks, Inc.
Chapter 27: Electrical Guidelines and Warnings