WARNING: Do not leave a fiber-optic transceiver uncovered except when
inserting or removing a cable. The rubber safety cap keeps the port clean
and prevents accidental exposure to laser light.
4. Cover the fiber-optic cable connector with the rubber safety cap.
Connecting an ACX1000 or ACX1100 Fiber-Optic Cable
ACX Series routers have field-replaceable unit (FRU) optical transceivers to which you
can connect fiber-optic cables.
Before you begin connecting a fiber-optic cable to an optical transceiver installed in a
router, ensure that you have taken the necessary precautions for safe handling of lasers
(see “General Laser Safety Guidelines for Juniper Networks Devices” on page 171).
To connect a fiber-optic cable to an optical transceiver installed in an ACX Series router:
WARNING: Do not look directly into a fiber-optic transceiver or into the ends
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected
to transceivers emit laser light that can damage your eyes.
1. If the fiber-optic cable connector is covered by a rubber safety cap, remove the cap.
Save the cap.
2. Remove the rubber safety cap from the optical transceiver. Save the cap.
3. Insert the cable connector into the optical transceiver (see Figure 31 on page 124).
Figure 31: Connecting a Fiber-Optic Cable to an Optical Transceiver
Installed in an ACX Series Router
g027016
Fiber-optic cable
Transceiver
4. Secure the cables so that they are not supporting their own weight. Place excess cable
out of the way in a neatly coiled loop. Placing fasteners on a loop helps cables maintain
their shape.
Copyright © 2017, Juniper Networks, Inc.124
ACX1000 and ACX1100 Universal Access Router
To Next Page
Loading...
Need help?
General
