EasyManuals Logo

Juniper SRX100 Hardware Guide

Juniper SRX100
154 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #62 background imageLoading...
Page #62 background image
4. If you are using wall anchors to support the chassis, install two pairs of anchors
on the wall, spaced 19 in. (48.3 cm) apart.
5. Have one person grasp the sides of the device, lift it, and position it on the wall.
6. Have a second person install two pairs of mounting screws through the bracket
holes on either side of the device to secure it to the wall.
7. Verify that the mounting screws on one side are aligned with the mounting
screws on the opposite side and that the device is level (see Figure 10 on page
44).
Figure 10: Hanging the SRX100 Services Gateway on a Wall
Related Topics Required Tools and Parts for Installing and Maintaining the SRX100 Services
Gateway on page 29
Preparing the SRX100 Services Gateway for Wall-Mount Installation on page 37
SRX100 Services Gateway Safety Requirements, Warnings, and Guidelines on
page 39
Installing the SRX100 Services Gateway on a Desk on page 42
Installing the SRX100 Services Gateway in a Rack on page 40
Connecting the SRX100 Services Gateway to the Power Supply on page 45
44 Installing the SRX100 Services Gateway on a Wall
SRX100 Services Gateway Hardware Guide

Table of Contents

Other manuals for Juniper SRX100

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper SRX100 and is the answer not in the manual?

Juniper SRX100 Specifications

General IconGeneral
Routing protocolsBGP, IS-IS, MPLS, OSPF
Switching protocolsVLAN 802.1Q, 802.3ad/LACP, STP
Supported network protocolsIPv4, IPv6, CLNS
Firewall securityYes
Security algorithms3DES, DES
Authentication methodRADIUS, RSA SecureID, LDAP
VPN supportIPsec VPN
Data transfer rate0.1 Gbit/s
Input voltage100 - 240 V
Input frequency50/60 Hz
Heat dissipation35 BTU/h
Power requirements100-240, 50/60
Power over Ethernet (PoE)No
Power consumption (typical)30 W
SafetyUL 60950-1, CSA 60950-1, AS / NZS 60950-1, AS / NZS 60950-1, CB Scheme, EN 60950-1
CertificationFCC Class B ICES class B AS / NZS CISPR22 Class B AS / NZS CISPR22 Class B VCCI Class B EN 55022 Class B, EN 300386
Mounting typeRack mounting
Internal memory1024 MB
Storage temperature (T-T)-20 - 70 °C
Operating temperature (T-T)0 - 40 °C
Weight and Dimensions IconWeight and Dimensions
Weight1100 g
Dimensions (WxDxH)216 x 147 x 36 mm

Related product manuals