Related Topics ■ Required Tools and Parts for Installing and Maintaining the SRX100 Services
Gateway on page 29
■ Grounding the SRX100 Services Gateway on page 47
■ Connecting and Organizing Interface Cables to the SRX100 Services Gateway
on page 46
■ SRX100 Services Gateway General Safety Guidelines and Warnings on page 93
Connecting and Organizing Interface Cables to the SRX100 Services Gateway
You can connect the interfaces installed in the services gateway to various network
media. Each type of interface on a services gateway uses a particular medium to
transmit data. You must configure each network interface before it can operate on
the device.
To connect and organize the interface cable to the device:
1. Have ready a length of the type of cable used by the interface.
2. Insert the cable connector into the cable connector port on the interface faceplate.
3. Arrange network cables as follows to prevent them from dislodging or developing
stress points:
■ Secure cables so that they are not supporting their own weight as they hang
to the floor.
■ Place excess cable out of the way in neatly coiled loops.
■ Use fasteners to maintain the shape of cable loops.
Related Topics ■ Connecting the SRX100 Services Gateway to the Power Supply on page 45
■ Grounding the SRX100 Services Gateway on page 47
■ Interface Cable and Wire Specifications for the SRX100 Services Gateway on
page 119
■ SRX100 Services Gateway Installation Safety Guidelines and Warnings on page
97
46 ■ Connecting and Organizing Interface Cables to the SRX100 Services Gateway
SRX100 Services Gateway Hardware Guide
To Next Page
Loading...
