KeeNetic Lite KN-1310 User Manual

Example
(config-if)> tunnel eoip id 50
Network::Interface::Tunnel: "Gre0": eoip id interface set to auto.
(config-if)> no tunnel eoip id
Network::Interface::Tunnel: "Gre0": eoip id was reset.
History
Version Description
The interface tunnel eoip id command has been
introduced.
2.08
3.16.100 interface tunnel source
Description Set the local end of tunnel. If it is used in conjunction with an automatic IPSec
connection associated with the tunnel, then the reception mode of IPsec IKE
connections is activated to establish a secure tunnel.
Command with no prex resets the setting.
Prex no Yes
Change settings Yes
Multiple input No
Interface type Tunnel
Synopsis
(cong-if)> tunnel source (auto | ‹interface› | ‹address› )
(cong-if)> no tunnel source
Arguments
DescriptionValueArgument
Set the current working WAN interface.Keywordauto
Full interface name or an alias.Interface
name
interface
Local IP-adress of the tunnel.IP-addressaddress
Example
(config-if)> tunnel source auto
Network::Interface::Tunnel: "Gre0": source interface set to auto.
(config-if)> no tunnel source
Network::Interface::Tunnel: "Gre0": source was reset.
History
Version Description
The interface tunnel source command has been
introduced.
2.08
The auto argument has been added.2.09
Keenetic Lite (KN-1310) — Command Reference Guide
143
Chapter 3 Command Reference

KeeNetic Lite KN-1310 Specifications

General

Brand	KeeNetic
Model	Lite KN-1310
Category	Network Router
Language	English