KeeNetic Lite KN-1310 User Manual

2.1.1 Entering a group
Some of the node commands (containing a group of child commands) can be “entered”
to allow direct executing of the child commands without typing the node name as prex.
In this case the prompt is changed to indicate the entered group.
The exit command or [Ctrl]+[D] key combination can be used to exit a group.
For example, after entering the interface group the command line prompt is changed to
(config-if):
(config)>interface FastEthernet0/Vlan2
(config-if)>ip address 192.168.15.43/24
Network address saved.
(config-if)>[Ctrl]+[D]
(config)>
2.2 Getting Help and auto-completion
To make the conguring process as comfortable as possible, the CLI provides
auto-completion of commands and parameters, hinting the operator, which commands
are available at the current level of nesting. Auto-completion works by pressing [Tab].
Example:
(config)>in[Tab]
interface - network interface configuration
(config)> interface Fa[Tab]
Usage template:
interface {name}
Variants:
FastEthernet0
FastEthernet0/Vlan1
FastEthernet0/Vlan2
(config)> interface FastEthernet0[Tab]
Usage template:
interface {name}
Variants:
FastEthernet0/Vlan1
FastEthernet0/Vlan2
(config)> interface FastEthernet0[Enter]
(config-if)> ip[Tab]
address - set interface IP address
alias - add interface IP alias
dhcp - enable dhcp client
Command Reference Guide — Keenetic Lite (KN-1310)
22
Chapter 2 Introduction to the CLI

KeeNetic Lite KN-1310 Specifications

General

Brand	KeeNetic
Model	Lite KN-1310
Category	Network Router
Language	English