EasyManuals Logo

Keithley 2600a series User Manual

Keithley 2600a series
696 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #396 background imageLoading...
Page #396 background image
19-74 Return to Section Topics 2600AS-901-01 Rev. B / September 2008
Section 19: Remote Commands Series 2600A System SourceMeter® Instruments Reference Manual
lan.linktimeout
Attribute Sets the LAN link time-out period.
Default 20
TSP-Link
accessibility
This attribute can be accessed from a remote TSP-Link node.
Usage timeout = lan.linktimeout -- Reads LAN timeout period.
lan.linktimeout = timeout -- Writes LAN timeout period.
timeout The LAN link monitor time-out period (in seconds).
Remarks • You must enable the command lan.autoconnect before you can use this attribute.
• The time-out value represents the amount of time that passes before the instrument disconnects
from the LAN due to the loss of the LAN link integrity.
• The LAN interface does not disconnect if the connection to the LAN is re-established before the
time-out value expires.
• If the LAN link integrity is not restored before the time-out value expires, the instrument begins to
monitor for a new connection.
lan.lxidomain
Attribute Sets the LXI domain.
Default 0
TSP-Link
accessibility
This attribute can be accessed from a remote TSP-Link node.
Usage domain = lan.lxidomain -- Reads LXI domain.
lan.lxidomain = domain -- Writes LXI domain.
domain The LXI domain.
Remarks • The value of this command must be a number between 0 and 255.
• The default value is 0.
• All outgoing LXI packets are generated with this domain number.
• Incoming LXI packets without the same domain number are ignored.
lan.nagle
Attribute Enables the use of the LAN Nagle algorithm.
Default lan.ENABLE
TSP-Link
accessibility
This attribute can be accessed from a remote TSP-Link node.
Usage state = lan.nagle -- Reads nagle state.
lan.nagle = state -- Writes nagle state.
state Enables the LAN Nagle algorithm.
Use one of the following values for state:
lan.ENABLE Enables the Nagle algorithm.
lan.DISABLE Disables the Nagle algorithm
Remarks • Use this attribute to enable or disable the Nagle algorithm on Transmission Control Protocol
(TCP) connections.
• lan.ENABLE permits the instrument to use the Nagle algorithm with future TCP connections.
• lan.DISABLE disables the Nagle algorithm for future TCP connections.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Keithley 2600a series and is the answer not in the manual?

Keithley 2600a series Specifications

General IconGeneral
BrandKeithley
Model2600a series
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals