19-88 Return to Section Topics 2600AS-901-01 Rev. B / September 2008
Section 19: Remote Commands Series 2600A System SourceMeter® Instruments Reference Manual
localnode.password
Attribute Sets the password for the remote interfaces.
TSP-Link
accessibility
This attribute can be accessed from a remote TSP-Link node.
Usage localnode.password = password
password String containing the remote interface password.
Remarks • This attribute stores the password set for any remote interface.
• If the attribute localnode.passwordmode is active, a password is required to access the
command interface, modify the password or LAN settings, and to access the virtual front panel.
• You cannot retrieve a lost password from any command interface.
• The password can be reset by resetting the LAN from the front panel or by assigning an empty
string to this attribute.
Details
Password management in Section 17
Also see
localnode.passwordmode
localnode.passwordmode
Attribute Enables the password mode over a remote interface.
TSP-Link
accessibility
This attribute can be accessed from a remote TSP-Link node.
Usage mode = localnode.passwordmode -- Reads password mode.
localnode.passwordmode = mode -- Writes password mode.
localnode.passwordmode = mode
mode = localnode.passwordmode
Set the password mode to one of the following:
localnode.PASSWORD_NONE Disables all passwords.
localnode.PASSWORD_WEB Enables password only on the web interface.
localnode.PASSWORD_LAN Enables password on all the Ethernet and web interfaces.
localnode.PASSWORD_ALL Enables passwords over all command interfaces and
the web interface.
Remarks • Configure the password mode to require passwords.
Details
Password management in Section 17
Also see
localnode.password
To Next Page
Loading...
Need help?
General
